Proline® Fuel Gas Cap Primer For Homelite A01372A UP05955 USA
Proline® fuel cap with built-in primer for Homelite XL, XL2, SUPER 2, 180,192, 200, LIL RED plus many more chainsaws. These are manufactured in USA using NO GLUE/EPOXY. The primer has only ONE inlet tube like the original. We do not use cheap snap in primers for our caps. For proper fitment, please match our part with yours; actual pictures are shown. With OVER 384 Sold 100% satisfaction GUARANTEED or your money back.
Please NOTE: Our inlet( 7/64) is smaller than the OEM so you might need to snip the tip of your old fuel line or replace your fuel line.
- Fuel cap with primer
- Inlet size 7/64
- NO Glue or Epoxy used to assemble
- Single Inlet Like OEM
- Replaceable primer
- Simple replacement
Replaces Homelite OEM #
We offer 120 day warranty against manufactures defects.
Posted by SH on Aug 4th 2020
Received the cap sooner than estimated. Fit my Homelite saw perfectly and seems to be a lot sturdier than the original. I like the fact that I can replace the bulb if needed.
Posted by Tim Clarke on Jul 27th 2020
Perfect fit for my little red Homelite chainsaw. Great price as well. Fast shipping!
Primer bulb & cap
Posted by i on May 23rd 2020
Well informed and prompt shipment
Best service ever
Posted by alfred meyer on May 20th 2020
My old chain saw wouldn't run because of a broken primer bulb. Sawzilla had what I wanted at 1/2 the price of some other online stores. The first cap I received was broken in shipping. I emailed them and had another in two days with apologies and concern for my satisfaction. Great job
works after improvising
Posted by Frank on May 18th 2020
The connector on the bulb was to small for my hose. Had to improvise to get it to work. Not sure if it will continue to work.
Posted by G. Turner on May 17th 2020
Part works fine. I took a fine piece of steel wire and crimped the hose onto the smaller nipple. No problem. Part looks to be better made than competitors.
Posted by John Botts on May 5th 2020
Part fits and will work, but the fitting on the new primer bulb is slightly smaller than the stock pickup hose diameter. It will work OK if you cut a small section off the existing hose and push the new hose end over the nipple. Not big deal, but the new part should be exactly like the original. It's not.
Posted by M.Ferringer on Apr 29th 2020
It came in good time! It works well! One minor problem, the hose from the saw is bigger across then the piece from the cap.
I jammed it on and tried it! It works so I have used it as is!
I've kept your info in the case, just in case! Thanks a lot! MF
Find Similar Products by Category
Customers also viewed